How To Configure AutoTune

Follow
To configure your AutoTune, please follow the directions below. Please note you will need an AutoTune kit.
  1. Select Power Commander Tools > Configure > AutoTune
  2. Select the AutoTune Enabled box to enable or disable AutoTune
  3. Select the Enable Hardware Switch box. When selected, AutoTune will not start until the map switch is toggled.
  4. Enable or disable the Require Run Time
    • Minimum Run Time is the length of time after startup before AutoTune starts
  5. Enable or disable the Require Engine Temp
    • Minimum Temp - AutoTune will not start until this engine temperature is reached. Enter a temperature in Fahrenheit if Harley ECM Data is enabled and configured. For an analog temperature sensor, the units are dependent on the settings entered in the Engine Temperature tab.
  6. Enter the Trim Settings
    • The Max Enrichment Trim/Max Enleanment Trim is the maximum percentage of fuel changes AutoTune will make during an AutoTune session.
  7. Click OK to accept the changes.

For additional AutoTune resources -- including manuals, software downloads, and firmware downloads, please visit our Downloads Center. And if you need additional help, please feel free to contact us.

 
Was this article helpful?
5 out of 11 found this helpful

Comments

0 comments

Please sign in to leave a comment.