Power Commander III: Powering up the PCIIIUSB


The Power Commander needs to be constantly powered in order to communicate fully with the computer. It should have a constant green light on. Make sure you have a fresh (above 8.5 volts) 9 volt battery if using the battery adapter. If using the bike's power, most bikes need to be running to provide the constant power needed rather than just turning on the key. Make sure the USB connector is fully seated into the Power Commander. If there is any silver showing on the connector, it is not completely plugged in. It is a tight snap-in fit connection.

For additional Power Commander III resources -- including manuals, software and firmware downloads, please visit our Downloads Center. And if you need additional help, please feel free to contact us.

Was this article helpful?
7 out of 12 found this helpful



Please sign in to leave a comment.